ECA Boiler Error Codes: E/F Codes Meaning and Fixes
Independent guide — no official affiliation with the platforms mentioned.
Resposta curta
On ECA boilers, E1/E2 indicate flame loss and overheat, E3 flue/smoke issues, E5-E7 NTC sensor faults; on some models F codes carry similar meanings. The common E1 (no flame) appears with a closed gas valve or ignition fault; the valve check + 1.5 bar pressure + reset trio fixes most cases. Repeated codes point to pump, sensor or gas valve faults and require authorized service.
Fonte oficial
eca.com.tr
Model-based error tables and the authorized service finder are on the official ECA support page.
01 — Solução passo a passo
Solução passo a passo
STEP 01
Identify the code and model
Note the code (E1, E3 etc.) and the boiler model (ECA Confeo Premix, Felis etc.). Search the official ECA support page for a model-specific table; the same code can mean different things across models.
STEP 02
E1/E2 — flame and overheat checks
Is the gas valve open? Is pressure 1-2 bar? Are radiator valves closed? Check all three: open valves, fill low pressure to 1.5 bar via the loop, reset. For E2 opening all valves matters especially; overheat usually comes from a closed circuit.
STEP 03
E3 — flue/smoke error
With E3, inspect the flue first: blockage, icing or strong wind backpressure. On condensing models the condensate drain may be frozen or blocked. If nothing is visible, call service for a pressure switch/hose fault.
STEP 04
E5-E7 — NTC sensor faults
These are not user-fixable; sensors must be replaced. Power-cycling does not help — sensor resistance must be measured and the part replaced. Open an authorized service ticket.
Do not open the boiler casing; due to gas and electrical safety, internal work must be done by authorized service only.
STEP 05
Use reset correctly
Hold reset for 3-5 seconds at once; rapid repeated presses can lock the board. After reset the boiler enters the ignition cycle within 3-7 seconds; if no flame forms the code returns — do not exceed three consecutive resets.
Dicas
- Annual pre-winter maintenance prevents most E codes and keeps warranties valid.
- After a power cut, unplugging the boiler for 1-2 minutes resets some board errors.
- The condensate hose under the boiler can freeze; raising the heat setting does not mask an unprotected outdoor line.
02 — Perguntas frequentes
Perguntas frequentes
My ECA boiler shows a pressure-drop issue with an E code — what now?
Continuously dropping pressure means the filling loop is not fully closed, the expansion vessel is faulty, or there is a leak. Close the loop fully and monitor; more than one drop in 24 hours warrants service — the E code is secondary here.
Are ECA Premix codes different?
Yes. Confeo Premix and Felis Premix series use a different, more detailed code set; modulation/sensor faults get dedicated codes. The model-specific official table is more accurate than general interpretations.
The boiler gave an E code on first startup — summer mode?
In summer mode only hot water runs; with radiator valves closed and the system long off, a transient code at first ignition is possible. Open valves, check pressure and one reset usually suffices.
Este guia resolveu seu problema?
Seu feedback melhora nossos guias — leva 10 segundos.
Os links neste guia apontam para páginas oficiais das plataformas. As etapas podem mudar com atualizações; verifique a data da página.
03 — Guias relacionados